Direct Connect connects Tencent Cloud with the user IDC with a dedicated physical line. After configuring the Direct Connect gateway and dedicated tunnel on the Tencent Cloud side, users need to configure routes on the local IDC. Using the layer-3 sub-interfaces to connect to Tencent Cloud is recommended.
Note:
This document only introduces the local routing configurations associated with Tencent Cloud Direct Connect. For other information, please see the local router documentation or consult your router provider.
Routing Configuration
Note:
It's recommended that you use the default configurations of Keepalive
and holdtime
for the BGP connection between the two peers. The holdtime
is three times the interval at which keepalive messages are sent. The recommended holdtime
value is 180s.
interfaces <interface_number>
description <interface_desc>
undo portswitch
undo shutdown
speed <interface_speed>
duplex full
undo negotiation auto
commit
interface <interface_number>.subinterface-number
description <subinterface_desc>
dot1q termination vid <vlanid>
ip address <subinterface_ipaddress> <subinterface_netmask>
bgp <as_number>
peer <bgp_peer_address> as-number <bgp_peer_as_number>
peer <bgp_peer_address> password cipher <bgp_auth_key>
peer <bgp_peer_address> description <bgp_desc>
ipv4-family unicast
peer <bgp_peer_address> enable
commit
bgp <as_number>
router-id <route_id>
peer <bgp_peer_address> bfd min-tx-interval <time value> min-rx-interval <time value> detect-multiplier <value>
Was this page helpful?