Parameter | Configuration |
Gateway name | Enter the VPN gateway name (up to 60 characters) |
Region | Display the region of the VPN gateway |
AZ | Select the availability zone of the current gateway |
Protocol Type | IPSec and SSL protocols are supported. |
Bandwidth cap | Set a reasonable bandwidth cap for the VPN gateway according to the actual application scenarios. |
Associated Network | This parameter specifies whether you create a CCN-based VPN/VPN gateway or a VPC-based VPN/VPN gateway. If you want to use a VPN connection to enable interconnection with multiple VPCs or other Direct Connect networks, create a CCN-based VPN. Note: You cannot associate the CCN-based VPN gateway with a CCN instance during its creation. You can associate a created VPN gateway to a CCN instance in the gateway details page. If you create a policy-based VPN tunnel, you also need to enable the route published to the CCN in the IDC IP range of the VPN gateway. If you want to communicate with a single VPC by using a VPN connection, create a VPC-based VPN. |
Network | If you set Associated Network to VPC, you must select the VPC that you want to associate with the VPN gateway.After you create a gateway for a CCN instance, you must associate the created gateway with the CCN instance on the details page. For more information, see Associating a CCN instance. |
SSL VPN Connections | If you select SSL for Protocol type, you must configure this parameter. The number of supported VPN connections vary based on the gateway. For more information, see Use Limits. |
Tag | Tags mark VPN gateway resources so that these resources can be queried and managed efficiently. Tag is not a required configuration. You can decide whether to configure it according to your demand. |
Billing Mode | The SSL VPN gateway supports only the pay-as-you-go billing mode. |
Was this page helpful?