- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- Private NAT Gateway Operation Guide
- Practical Tutorial
- Enabling Cross-VPC Access to Public Network via Standard NAT Gateway
- Enabling Mutual Access between a Specified VPC Subnet and Public Network Resources via Private NAT Gateway
- Enabling Secure Mutual Access with Public Network via Public CLB and NAT Gateway
- Adjusting the Priorities of NAT Gateways and EIPs
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- Private NAT Gateway Operation Guide
- Practical Tutorial
- Enabling Cross-VPC Access to Public Network via Standard NAT Gateway
- Enabling Mutual Access between a Specified VPC Subnet and Public Network Resources via Private NAT Gateway
- Enabling Secure Mutual Access with Public Network via Public CLB and NAT Gateway
- Adjusting the Priorities of NAT Gateways and EIPs
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
After the NAT Gateway is created, you need to configure routing policies to direct the subnet traffic to the NAT Gateway.
There are two options:
Method 1: Configure in the NAT Gateway console
Method 2: Configure in the Route Table console
Directions
Method 1: Configure in the NAT Gateway console
1. Log in to the NAT Gateway console.
2. In the NAT gateway list, click the VPC ID of the target NAT gateway.
3. Click Subnet in the VPC details page.
4. In the Subnets list, find the subnet that needs to access the internet and click the route table ID.
5. Click +New routing policies on the Basic Information page.
6. In the Add route box, enter the destination (public IP range), select NAT gateway in Next hop type and choose an existing NAT gateway.
7. Click Create to complete.
Method 2: Configure in the Route Table console
1. Log in to the VPC console and click Route Tables on the left sidebar.
2. Locate the route table associated with the subnet that needs to access the Internet, and click its ID/Name to enter the details page.
3. Click +New routing policies on the Basic Information page.
4. In the Add route box, enter the destination (public IP range), select NAT gateway in Next hop type and choose an existing NAT gateway.
5. Click Create to complete.
Yes
No
Was this page helpful?