- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- Private NAT Gateway Operation Guide
- Practical Tutorial
- Enabling Cross-VPC Access to Public Network via Standard NAT Gateway
- Enabling Mutual Access between a Specified VPC Subnet and Public Network Resources via Private NAT Gateway
- Enabling Secure Mutual Access with Public Network via Public CLB and NAT Gateway
- Adjusting the Priorities of NAT Gateways and EIPs
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- Private NAT Gateway Operation Guide
- Practical Tutorial
- Enabling Cross-VPC Access to Public Network via Standard NAT Gateway
- Enabling Mutual Access between a Specified VPC Subnet and Public Network Resources via Private NAT Gateway
- Enabling Secure Mutual Access with Public Network via Public CLB and NAT Gateway
- Adjusting the Priorities of NAT Gateways and EIPs
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
This document describes how to purchase NAT gateways in the NAT Gateway console.
Directions
1. Log in to the NAT Gateway console.
2. Select a region and VPC, and then click Create.
3. In the NAT gateway purchase page, complete the parameters and purchase.
Parameter | Description |
Gateway name | Enter the NAT gateway name with up to 60 characters. |
Region | Select a region for the NAT gateway. |
VPC | Select a VPC for the NAT gateway. |
Gateway type | The types include: Small (a maximum of 1,000,000 connections) Medium (a maximum of 3,000,000 connections) large (a maximum of 10,000,000 connections) |
Outbound bandwidth cap | The maximum outbound bandwidth cap of the NAT gateway. Valid values: 10, 20, 50, 100, 200, 500, 1000, 2000 and 5000. Unit: Mbps. |
EIP configuration | You can associate the NAT gateway with existing EIPs or create new EIPsfor it. Using existing EIPs: Make sure that you have idle EIPs in the same region as the NAT gateway. Creating new EIPs: Bill-by-traffic general BGP IPs are created automatically. You can configure the EIP quantity and the bandwidth cap as needed. |
Note:
The traffic going to the internet is limited by the bandwidth cap of both the NAT gateway and EIPs. The smaller bandwidth cap prevails.
For more information about NAT gateway-related operations, see Getting Started.
Yes
No
Was this page helpful?