- Introduction
- Purchase Guide
- Getting Started
- Advanced Guide
- Serverless Framework Component
- Operation Guide
- Practical Tutorial
- FAQs
- Framework Support
- Deploying Framework on Command Line
- Quickly Deploying Egg Framework
- Quickly Deploying Koa Framework
- Quickly Deploying Express Framework
- Quickly Deploying Next.js Framework
- Quickly Deploying Nuxt.js Framework
- Quickly Deploying Flask Framework
- Quickly Deploying Laravel Framework
- Quickly Deploying Nest.js Framework
- Quickly Deploying Django Framework
- Quickly Deploying Native WordPress Application
- Contact Us
- Introduction
- Purchase Guide
- Getting Started
- Advanced Guide
- Serverless Framework Component
- Operation Guide
- Practical Tutorial
- FAQs
- Framework Support
- Deploying Framework on Command Line
- Quickly Deploying Egg Framework
- Quickly Deploying Koa Framework
- Quickly Deploying Express Framework
- Quickly Deploying Next.js Framework
- Quickly Deploying Nuxt.js Framework
- Quickly Deploying Flask Framework
- Quickly Deploying Laravel Framework
- Quickly Deploying Nest.js Framework
- Quickly Deploying Django Framework
- Quickly Deploying Native WordPress Application
- Contact Us
What should I do if Serverless Framework prompts that "component" input is requires to run custom methods?
When the Serverless Framework CLI is started, if a component is referenced in the
yaml configuration file by default, you need to make sure that the folder is empty before you can run the component installation command properly.
Running the serverless create command again in an empty folder will not cause this error.
Yes
No
Was this page helpful?